surprised-rainbow-faceSo awhile back I came across an instructables article regarding using some ikea lack tables to make a 3dprinter enclosure…..

I love ikea….

So this was the project.  http://www.instructables.com/id/3d-Printer-Enclosure-from-Upcycled-Furniture/

I went to ikea.  Got 2 lack tables and put them together…. I want my printer higher up.  ELEVATE TO THE LEVEL OF THE GODS!!! no.  just high enough I can watch it cause I like to watch it go back and forth while I make printer noises.

So I ordered a 3rd table.  Put it on top.  Sweet.  Much better.  I moved the printer into the enclosure this weekend (no sides put on it yet) and decided I needed to get the lighting in place.  So I took some neopixel strips I had laying around and hooked them up to an arduino.

13694706_1455593267790887_1215760066_nOk, so that’s now how I am leaving it 🙂  but it did look cool.   Now I can set the colors.  Plain white for printing.  I am trying to figure out how in octoprint to get a hook in to detect when it’s heating up.  That way I can turn the lights orange or red to indicate heating phase.

 

 

So I did a timelapse and a vid.   The vid of the whole rig setup

Here is the timelapse test print

 

I am working more on trying to get some good photo and video in with these projects too.  If you like the videos give a thumbs up and a subscribe.